2023 Kia Forte GT Manual 1.6L

A brand-new Kia Cerato is approximately priced at RM 99,214.

A brand-new Kia Cerato is approximately priced at RM 99,214.

Kia Cerato typically uses gasoline as its fuel. The common Kia Cerato models are often compatible with gasoline grades of RON 95 or above. However, specific fuel requirements may vary depending on the vehicle configuration and engine technology.

To replace the wiper blades on your Kia Cerato, you can follow these steps: first, lift the wiper arm so that it separates from the windshield. Then press or twist the fixation device at the connection of the wiper blade, and pull out the old wiper blade. Next, align the new wiper blade with the slot and insert it, making sure the fixation device is locked in place. Finally, lower the wiper arm. Please note that you should proceed gently to avoid damaging any vehicle parts.

To replace the rear wiper blade on a Kia vehicle, follow these steps: first, lift the rear wiper arm to a 90-degree angle from the rear windshield. Next, press the button or clip located at the connection point between the wiper blade and the arm while pushing the blade along the direction of the arm to remove it. After that, align the new wiper blade with the slot on the wiper arm and gently push it in until you hear a click, indicating it's securely in place. Finally, lower the wiper arm and check that the new blade is firmly installed and functions properly. It's important to note that the replacement method may vary slightly among different Kia models.

To lift the wipers on a Kia Cerato, you can typically do as follows: first, turn off the vehicle's ignition. Then, within 10 seconds, pull the windshield wiper lever towards the direction of steering wheel , and the wipers will move to the maintenance position. At this point, you can easily lift the wiper blades.

The common size of wiper blade for Kia Cerato is usually 24 inches and 16 inches for the front windshield. However, please note that there may be slight differences for different years and configurations of models.

The steps to replace the rear windshield wiper on a car are as follows: First, raise the rear wiper arm, press the button or latch on the wiper blade, then pull out the old wiper blade directly along the direction of the wiper arm. Next, align the new wiper blade with the slot of the wiper arm and insert it, making sure it is firmly installed. Be mindful of the force you use during this process to avoid damaging the wiper arm and related parts. There may be subtle differences for different car models. For example, some models' rear wiper arms may require special tools or specific methods for disassembly and installation.

The 2024 Kia Cerato hatchback is priced between approximately RM 86,591 and RM 115,642. Prices vary across different trim levels; for instance, the 1.6L model comes in at a relatively lower price, while the 2.0L variant is priced slightly higher. However, it's important to note that the specific pricing may fluctuate due to factors such as dealership variances, regional differences, and market supply and demand.

To replace the rear windshield wiper on a Kia Cerato, first lift the wiper arm so that it is perpendicular to the windshield. Then, press the button at the connection between the wiper blade and the wiper arm, and pull out the old wiper blade. Next, align the slot of the new wiper blade with the hook on the wiper arm, insert it and ensure it is secure. Finally, lower the wiper arm to complete the replacement.